How do I setup PenMount Non-PnP RS-232 controllers using the PenMount Windows Universal Driver?
The PenMount Windows Universal Driver V2.1.0.234 or later versions support Non-PnP RS-232 PenMount controllers. V2.1.0.234 will automatically change every COM port settings to allow detection of PenMount devices on system start up. With PenMount Universal Driver V2.1.0.263 or later, user must setup the ports which will detect non-PnP RS-232 PenMount controllers manually, please modify the "Driverinstall.ini" as follows, before you install the device driver.
[Install]
ENUM = 1 ; This will allow the following ENUM section to take effect.
[ENUM]
Total = 6 ; Set up the total COM port number
COM5 = 1 ; Setup the ports that will allow PenMount non-PnP device detection , in this case , COM5.